Need help?Do you have a question about the John Lewis Martha Sleigh cotbed and is the answer not in the manual?
General| Type | Cot Bed |
|---|---|
| Assembly Required | Yes |
| Finish | Painted |
| Convertible | Yes |
| Mattress Size Required | 140cm x 70cm |
| Material | Pine |
| Safety Standards | BS EN 716-1:2017 |
Attach one Side panel to an End panel using two 45mm bolts, without fully tightening.
Attach the base to the cot assembly using four 65mm bolts, without fully tightening.
Attach the second Side panel with bolts and fit the Drawer trim using dowels.
Attach the second End panel, securing it with 65mm and 45mm bolts, then tighten all fixings.
Attach drawer handles to the front panel using screws and insert the cam pin.
Connect the drawer centre to the front panel and attach drawer sides using wood screws.
Insert drawer bases into the slots and secure the drawer back using wood screws.
Slide the completed drawer into the cot's runners.
Clean the furniture with a damp cloth and mild soap; avoid harsh chemicals.
Covers assembly safety, warnings about heat, missing parts, and suffocation hazards.
Specific safety advice for the toddler bed conversion, including placement and interaction.
To Next Page