John Lewis Mixit - Step Eleven

Top of Unit
W
A
L
L
W
A
L
L
W
A
L
L
G
G
G
I
1
4
Page 10
MXT 04/13
Step by step assembly instructions
Step Eleven
To prevent possible overbalancing we recommend that this unit is secured to a suitable wall by use of wall
strap (G) fitted to the Top of the unit.
Secure one end of the wall strap (G) to the wall.
Thread the other end of the wall strap (G) through the gap between the top (1) of the chest
and the back panel (4).
Working from the front of the chest, fix the wall strap (G) to the underside of the top (1) using the
wall strap screw (I).
Thread the screw through through the end of the wall strap (G) and into the pilot hole in the underside
of the top (1).
Do not fix the wall strap (G) to any other component.
! IMPORTANT !
Take care when drilling the wall that you do not drill into any pipes, wires etc. If in doubt, consult an expert.
Wall plug and screw not included.
See wall fixing guide at page 14.
1.
2.
3.
4.
5.