Model: GG-25PFC-D
25-Gallon Diesel Fuel Cart
(UN/DOT Approved)
Operator’s Manual
REV 06/15
OPERATOR’S MANUAL GG-25PFC-D FUEL CART
151 Snyder Ave.
Barberton, OH 44203
www.johndow.com
customerservice@johndow.com
4.
To load for transportation
1
. Load the fuel cart onto a trailer or truck bed and place in horizontal position. DO NOT place inside a vehicle trunk or inside the
passenger compartment.
2. Secure the container with proper restraining devices to prevent movement in all directions. Proper restraining devices include
tie-down straps, cables or chains that are in good condition and strong enough to withstand the forces that may be
encountered during transportation. There should not be any sharp edges in contact with the plastic tank. The restraining devices
may be wrapped around the tank body in the grooved ribs or around the molded handle. DO NOT attach restraining devices to the
ball valve, hose fittings, or fill cap.
3. It is the vehicle operator’s responsibility to comply with all federal, state, and local regulations for the transportation of gasoline,
and including the use of placards where required.
Storage
1. It is the user’s responsibility to review and comply with all local and state building and fire codes regarding allowed quantity of
fuel that may be stored and the approved storage locations.
2. Keep out of reach of children.
3. Store in well-ventilated area.
4. Keep away from flame, pilot lights, stoves, heaters, electric motors and other sources of ignition. DO NOT store inside a residence,
living space or basement.
5. DO NOT store in an attached garage that is connected to residence or dwelling.
6. DO NOT store in vehicle passenger compartment or vehicle trunk.
7. DO NOT store in direct sunlight.
1
11
3
2
4
7
8
5
10
8
9
9
Item Description Qty Part No.
1 Tank - 15 Gallon 1 N/A
2 Adapter O-Ring Groove 1 14GC-05
3 O-Ring 1 9464K39
4 1/2” NPT Swivel 90° Elbow 1 1501-8-8
5 1/2” NPT M x F Ball Valve 1 BV-1/2NPTMF
6 Dispensing Hose 1 80-593-14
7 Dispensing Nozzle 1 JL-5116-1
8
Model: GG-15PFC
Wheels 8.0 x 2.5 Pneumatic with 5/8”
Bearing
2 P825-20S-R
Model: GG-25PFC
Wheels 8.0 x 2.5 Pneumatic with 5/8”
Bearing
2 P1030-20S-R
9 Flat Washer 5/8” ID Zinc Plated 4 FRWSAW062
10 Axle Caps 5/8” ID Zinc Plated 1 14174
11 Fill Cap 1 201594
To Next Page
Need help?
General
