D
David BakerAug 6, 2025
What to do if no units show up on the display of my Johnson Controls YVAHP072B31S after startup, or an Adapter communication failure (S23) is detected?
- SSarah WashingtonAug 6, 2025
First, disable any commercial security software, ensuring to secure the network with a firewall of routers. Then, verify that all adapters are turned ON. Next, check that the LAN is properly wired between the adapter and the management computer, and that the power to the hub is ON. Finally, use a category five LAN cable up to 100m in length and connect the management computer and adapter to an Ethernet hub.


