To Next PageTo Next Page
Need help?Do you have a question about the Johnson Outdoors Bass Tender 10.6 and is the answer not in the manual?
General| Brand | Johnson Outdoors |
|---|---|
| Model | Bass Tender 10.6 |
| Category | Boat |
| Language | English |
Custom designed boat covers made from long-lasting vinyl.
Trailers designed for JOW-Sport & Leisure fishing boats available through local dealers.
Includes oar locking horn kits, oar lock socket kits, and oars.
Lists other watercraft offered, including deck boats, pedal boats, canoes, and kayaks.
Clean hull with mild detergent and water; use soft brush. Avoid plastic conditioners.
Scrape hull periodically to remove marine life; consider antifouling preservative.
Check and clean pump intake slots for 10.2 & 10.6 models.
Secure boat snugly with tie-down straps, do not overtighten to avoid hull distortion.
Rest boat weight on support bunks (min 3.5" wide, 5' long); tie down snugly.
Secure Watertender 9.4 in cradle or tow behind, use higher tow point for upward angle.
Enlist help, tilt motor, remove tie-downs, install drain plugs, step center for stability.
Attach swivel mounting bases to seats using fasteners; ensure snug but not overtightened.
Ensure transom, livewell, and bow drain plugs are correctly installed.
Use a 12V Deep Cycle Marine battery and connect wires correctly to terminals.
Oar lock kits are available; follow kit instructions for installation.
Verify transom, livewell, and bow drain plugs are installed prior to launching.
Drain accumulated water between deck and hull; do not store with water present.
Check capacity plate and ensure weight load and motor are within limits.
Attach motor to transom per manufacturer instructions; respect horsepower rating.
Connect trolling motor power wires to plug wires using provided connectors or soldering.
Control panel switch operates navigation lights on 10.6/11.3; install poles into sockets for 10.2.
Pump controlled by switch on control panel; circuit has a 2 amp fuse.
Some models have a separate circuit with a 7.5 amp fuse for accessories.
Mount accessories on the starboard deck surface next to the anchor well.
Mount accessories on the deck surface directly above the electrical control panel.
Mount transducer on the motor or a raised block on the port transom.
Connect accessory power for fish finders using bow circuit or control panel access.
Mount main fish finder unit on forward horizontal deck surfaces.
Mount transducer on trolling motor or raised transom block; avoid plastic-only mounting.
Connect fish finder power directly to the battery; consult installation instructions.
Place fish finder main unit on the deck in a convenient location.
