10
Original instructions
> English
(lower position) the system is activated. When water is present for
3 seconds in the bilge of the vessel, the alarm will trigger and a red
light will be activated simultaneously. The alarm and light will stay
on until either the water level drops below the detector level or the
operator places the switch in the “off” position (middle position).
Please note that in the “off” position, the red light will still activate
without the alarm, if there is water in the bilge of the vessel.
2. Make sure to test the detector. You may test your 72303 detector
by removing the mounting screw from the detector and submerging
the detector in a cup of water. The detector should activate after
4 seconds. Re-install detector after test is complete. If alarm does
not activate as required, a repositioning of the detector may be
necessary.
3. 72303-001/002 Ultima Switch Detector can be tested simply by
simultaneously placing fingertips over both sensor circles on the
side of the device for 3 seconds.
Maintenance:
Your Bilge Alert high water alarm will provide years of maintenance
free operation. In case of malfunction, make sure that detector is free
of floating debris. At all times keep all wire connections high and dry.
Warranty:
Your Bilge Alert high water alarm is covered by a 3-year limited Warranty.
To Next Page
Loading...