GETTING STARTED
Read the Owner's Manual before setting up the Johnson Elliptical Trainer. Place the
unit where it will be used before beginning the setup procedure.
MAKING A CHOICE OF SITE
The site should be well-lit and well-ventilated. Locate the E8000 on a structurally solid
and flat surface a few feet from the wall or any equipment. If the site has a heavy
plush carpet, to protect the carpeting and machinery, you should place a rigid plastic
base under the unit.
Please do not place the Total Body Elliptical Trainer in an area of high humidity, such
as the vicinity of a steam room, indoor pool, or sauna. Exposure to intensive water
vapour or chlorine could adversely affect the electronics, as well as other parts of the
machine. To make exercise a desirable daily activity for you, the Total Body Elliptical
Trainer should be in an attractive setting.
STABILIZING THE JOHNSON ELLIPTICAL TRAINER
After placing the unit where it will be used, check its stability. If the Elliptical E8000 is
placed on a slightly, uneven surface, adjusting the adjustable levelers located
underneath the base frame can help, but will not compensate for extremely uneven
surfaces. To adjust, loosen the nut, and turn the leveler until the rocking motion
ceases, and both levelers rest firmly on the floor. Retighten the nut.
SETUP THE ELLIPTICAL
UNPACKING THE TOTAL BODY ELLIPTICAL TRAINER
The Elliptical Trainer is carefully inspected before shipment so it should arrive in good
operating condition. Johnson Fitness ships the unit in the following pieces:
NOTE: If these parts are missing from the package, please contact Johnson Fitness or
the local authorised dealers at once.
0504
JOHNSON ELLIPTICAL E8000JOHNSON ELLIPTICAL E8000
Hardware Kit
(A)
(B)
(D)
(H)
(I)
(J)
(G)
(C)
(E)
(F)
Main Frame Assembly
Console Mast
Console Mast Boot
Dual-Action Handrails
Pedal Arms
Front Foot
Handlebar Set
Console
Accessory Tray
Hareware Kit
A
B
C
D
E
F
G
H
I
J
)
)
)
)
)
)
)
)
)
)
To Next Page
Loading...
Need help?
General
