Johnson J10RSRD User Manual

Apply Needle Bearing Assembly Grease to the 28
wrist pin bearings.
Install the bearings in the wrist
pin bore.
Align the bearings in the bore using
Wrist Pin Bearing
Tool, PIN 336660 .
Wrist Pin Bearing Tool
1. Bearings
.-----1
24911
Place the two wrist pin thrust washers on the tool
with flat side of the washers facing out.
j----_- 1
-
-
-
1. Wrist pin thrust washers
24910
-
POWERHEAD
ASSEMBLY - 25/30
Install the wrist pin through the piston and con-
necting rod, pushing the
tool out through the pis-
ton.
24442
Using Cone, PIN 318600, and Driver, PIN 318599,
install new wrist pin retaining rings in both wrist
pin retainer grooves of piston. When
installed, gap
of the ring
should be positioned opposite notch in
the piston.
2
DR3480 1
IMPORTANT: The connecting rod has no spe-
cific orientation. Support the piston
in Piston Cra-
dle, PIN 326573. Oil the wrist pin bore and wrist
pin.
1. Gap in retaining ring
2. Notch in piston
Repeat these steps for each piston.
24909
205
I
E
o
U
Qj
)(
~
Qj
~
ii
E

Johnson J10RSRD Specifications

General

Brand	Johnson
Model	J10RSRD
Category	Outboard Motor
Language	English