Johnson J10RSRD

BEARING AND SEAL
REMOVAL
IMPORTANT: Inspect bearings for damage
while
in place. If bearing is damaged, remove and
discard.
If the bearing is removed for any reason,
it must be replaced.
Driveshaft Seals
Use Puller Bridge, PIN 432127, and Small Puller
Jaws, PIN 432131, to remove the two driveshaft
seals. Discard the seals.
32545
GEARCASE
BEARING AND SEAL REMOVAL
Driveshaft Bearing
Use Puller Bridge, PIN 432127, and Small Puller
Jaws, PIN 432131 to remove the driveshaft bear-
ing and sleeve from the gearcase. Discard the
bearing.
273