Johnson J10RSRD User Manual

Clean and inspect all electrical components.
Replace damaged or corroded components prior
to returning the outboard to service.
Electric start-
ers should be disassembled, cleaned, flushed
with clean water, and treated with water displacing
electrical
spray prior to reassembly.
Remove carburetor for draining, disassembly and
cleaning.
Disconnect fuel supply hose from outboard. Drain
and
clean all fuel hoses, filters, and fuel tanks.
Inject a small amount of outboard lubricant into
spark plug holes and install new spark plugs.
Reinstall all removed or disconnected parts.
Run the outboard below 1500 RPM for one-half
hour on a 25:1 fuel/oil mixture.
Engine Dropped Overboard
(Running)
Follow the same procedures as Engine Dropped
Overboard (Not Running). However, if there is
any binding when the flywheel is rotated, it may
indicate a bent connecting
rod and no attempt
should be made to start the outboard. Powerhead
must be disassembled and serviced immediately.
MAINTENANCE
SUBMERGED
ENGINES
Engine Dropped Overboard
(In Salt Water)
Follow the same procedures used for Engine
Dropped Overboard (Not Running) and Engine
Dropped Overboard (Running).
Disassemble
and clean outboards that have been submerged in
salt water for prolonged periods of time. Electrical
components must be cleaned or replaced as nec- 3
essary.
Prolonged Submersion
(Fresh or
Salt Water)
Outboards that have been dropped overboard and
not recovered
immediately, must be serviced
within three hours of recovery.
Follow the same
procedures used for Engine Dropped Overboard
(Not Running) and Engine Dropped Overboard
(Running).
79
E
o
o
~
x
~
OJ
~
ii
t:
.s::

Johnson J10RSRD Specifications

General

Brand	Johnson
Model	J10RSRD
Category	Outboard Motor
Language	English