Power setting
The power will change in one increment each time the SET button is pressed.
After 15 seconds, the refrigerator will operate at the set power setting.
Setting 1
Setting 2
Setting 3
Setting 4
Setting 5
Fast cooling function
Press the temperature adjustment key until you enter the fast cooling mode.
When in operation, the fast cooling indicator will illuminate and the refrigerator
will operate at 2ºC.
The fast cooling mode ends if:
1.150 minutes of operation in fast cooling elapse.
2.The temperature setting is changed manually.
Freezer temperature control
The freezing temperature is relatively low in the "COLDEST" position (colder), and
higher in the "COLD" position (colder), so the "COLDER" position is usually used.
When the ambient temperature is high in summer, the temperature should be
within the range of "COLDER" to "COLD". If the ambient temperature is above
35°C, the "COLD" position should be used.
With the lowest ambient temperature in winter, the temperature should be in
the range from "COLDER" to "COLDEST". If the ambient temperature is
below 10°C, the "COLDEST" position must be used.
Fresh compartment description: The temperature of the Fresh drawer is -2 ≤ tcc
≤ 3. The maximum tcc must be as close as possible to 3°C, and cannot be higher
than this value. The compartment is not suitable for storing fresh vegetables
and fruit (which are sensitive to lower temperatures).
4.2 Noise in the unit
It may happen that your unit makes some unusual noises. In most cases these
are perfectly normal, but it is a good idea to familiarise yourself with them.
These sounds are caused by the circulation of the refrigerant in the refrigerant
circuit, and have become more pronounced since the introduction of CFC-free
To Next Page
Loading...
Need help?
General
