Johnson PL - Page 49

Maintenance - 47
Engine to transom mounting hardware, re-torque
(40 ft. lbs.)
DD
Electrical and ignition wires and connections,
inspect
DD
Gearcase lubricant replace 5 D D
Powerhead synchronization and linkage, inspect
(2)
7DD
Gearcase lubricant, inspect fill level and condition
of lube
5D
Fuel and oil filter(s) replace D
Propeller shaft splines, inspect and lubricate 7 D
Starter pinion shaft, inspect and lubricate
(3)
9D
Spark plugs, replace
(2)
D
Decarbonize 10 D
Driveshaft splines, inspect and lubricate 8 D
Water pump, inspect and replace D
(1) Also recommended at 10-Hour Inspection
(2) Emission-related component
(3) Do not use light duty penetrating lubricants
D
Dealer Performed Service
O
Operator Performed Service
4
Evinrude/Johnson anti-corrosion spray or Evinrude/Johnson “6 in 1” multi-purpose lubricant
5
Ultra-HPF gearcase lubricant
6 Power Trim/Tilt Fluid
7
Triple-Guard grease
8
Evinrude/Johnson Moly Lube P/N 175356
9 Starter Bendix Lube Only P/N 337016
10
Evinrude/Johnson Engine Tuner
Engine Maintenance and Inspection Schedule
Description
Engine
Care
Product
Frequency
Each Use 10-Hour Inspection Every 50 Hours or 6 months Every 100 Hours or Annually Every 200 Hours or Biannually