Maintenance - 45
Decarbonize 9 D
Breather and fuel lines, replace D
Valve tappet clearance, inspect
(2)
DD
Crankcase oil, replace
(4)
10 D D
Oil filter, replace D D
Driveshaft splines, inspect and lubricate 7 D
Water pump, inspect and replace D
Fuel filter, replace D
Carburetor, inspect D
Ignition timing, check D
Operator’s Guide, onboard O
Operator’s Guide, review O
Timing belt, inspect Replace every 4 years O
(1) Also recommended at 10-Hour Inspection
(2) Emission-related component
(3) Do not use light duty penetrating lubricants
(4) Replace every 100 hours or annually if Evinrude/Johnson ultra 4-Stroke synthetic blend oil is not used
D
Dealer Performed Service
O
Operator Performed Service
4 Evinrude/Johnson anti-corrosion spray or Evinrude/Johnson “6 in 1” multi-purpose lubricant
5 Ultra-HPF gearcase lubricant
6 Triple-Guard grease
7 Evinrude/Johnson Moly Lube™ P/N 175356
8 Starter Bendix Lube Only P/N 337016
9 Evinrude/Johnson Engine Tuner
10 Evinrude/Johnson ultra 4-Stroke synthetic blend oil
Engine Maintenance and Inspection Schedule
Description
Engine Care
Product
Frequency
Each Use
10-Hour
Inspection
Every 50 Hours
or 6 months
Every 100 Hours
or Annually
Every 200 Hours
or Biannually
To Next Page
Loading...
