39
38
Tether Anchorage Installation
If the car is not fitted with a child restraint
anchorage point:
For sedans only - drill a 9 mm hole in the parcel
shelf on the centre line of the seating position
as shown on page 27.
Install the anchor bolt as shown opposite.
For vehicles other than sedans - In Australia,
consult your nearest child restraint tting sta-
tion or trafc authority for vehicle inspection to
nd the best, correct position for the placement
of the anchorage point, and for the correct at-
tachment bolt length and use of spacers.
In New Zealand, consult the agent for the
vehicle.
Attachment
Bolt
Spacers
(if required)
Anchor
Fitting
Vehicle
Metal
Structure
Vehicle Trim
FRONT OF VEHICLE
Lock Washer
Nut
Reinforcing
Washer
Maintenance
HARNESS BUCKLE
To clean the buckle: rinse using warm
water. DO NOT use any soaps, solvents
or lubricants. Using anything other
than water can cause the buckle to
malfunction. Air dry.
When the buckle is operating correctly the
tongues will push in easily and the second
tongue will CLICK when it latches into
place.
If the buckle does not appear to be
working correctly get it checked or
replaced by contacting the retailer from
where it was purchased, or by contacting
Australia's Power Brands.
STORAGE
Remove the child restraint from the vehicle
seat if not in use for a long period of time.
Put the child restraint in a cool, dry place
where your child cannot access it.
SEAT COVER
Wash with cold water at less than 30
degrees C.
Do not iron.
Do not bleach or dry clean.
Do not twist the soft goods to dry with
great force. It may leave the seat cover with
wrinkles.
Hang dry the seat cover in the shade. Do
not tumble dry.
INFANT INSERT
Remove foam insert from Infant Insert
before machine washing.
See page 22 for instructions on re-insert-
ing foam insert into the Infant Insert.
PLASTIC AND METAL PARTS
Use only mild detergent, water and a soft
cloth to clean the car seat shell, handle
and harness straps. Air dry.
Do not use undiluted detergent, or other
solvents to clean - these may cause
damage.
HARNESS STRAPS
Shoulder harness straps are not remov-
able. Clean with mild detergent, water and
a soft cloth only.
To Next Page
Loading...
Need help?
General
