23 24
click both ISOFIX connectors into the ISOFIX anchor points. (Fig. 12)
! Make sure that both ISOFIX connectors are securely attached
to their ISOFIX anchor points. The colors of the indicators on
the both ISOFIX connectors should be completely green.
(Fig. 12.1)
! Check to make sure the base is securely installed by pulling on
the both ISOFIX connectors.
5. Please refer to step 2 in section 'a. Installation with 3-point-belt'
for adjustment of load leg.
The completely assembled base is shown as (Fig. 13)
! The ISOFIX connectors must be attached and locked onto the
ISOFIX anchor points. (Fig. 13.1)
! The load leg must be installed correctly with green indicator.
(Fig. 13.2)
6. Please refer to step 5, 6 in section 'a. Installation with 3-point-belt'
to use the infant child restraint.
7. To remove the base, press the secondary lock button (Fig. 14.1) first
and then the button (Fig. 14.2) on the latch connectors before
removing the base from the vehicle seat. (Fig. 14)
8. Fold ISOFIX connectors as (Fig. 15)
To Next Page
Loading...
Need help?
General
