Joie i-Gemm User Manual

11 12
3. Rotate the ISOFIX connectors 180
degrees until they are pointing in
the direction of the ISOFIX guides.
10
11
10
1
4. Line up the ISOFIX connectors with
the ISOFIX guides, and then
click both ISOFIX connectors into
the ISOFIX anchor points.
11
!
Make sure that both ISOFIX
connectors are securely attached
to their ISOFIX anchor points.
There should be two audible
clicks and the colors of the
indicators on the both ISOFIX
connectors should be completely
green.
11
-1
!
Check to make sure the base is
securely installed by pulling on
the both ISOFIX connectors.
5. After placing the base on the vehicle seat, extend the load leg to
floor
12
, When the load leg indicator shows green means it is
installed correctly, red means it is installed incorrectly.
12
-3
!
The load leg has 24 positions. When the load leg indicator shows
red this means the load leg is in the wrong position.
!
Make sure the load leg is in full contact with the vehicle floor pan.
!
Squeeze the load leg releasing button, then shorten the load leg
upwards.
12
3
1
2
13
1
2
The completely assembled base is
shown as
13
!
The ISOFIX connectors must be
attached and locked onto the
ISOFIX anchor points.
13
-1
!
The load leg must be installed
correctly with green indicator.
13
-2

Joie i-Gemm Specifications

General

Headrest	Yes
Certification	ECE R129/00
Mounting type	ISOFIX
Product color	Gray
Car seat group	0+ (0 - 13 kg; 0 - 15 months)
Adjustable backrest	No
Belt fastening type	5-point
Placement available	Rear-facing
Maximum child height	85 cm
Minimum child height	40 cm
Maximum weight capacity	13 kg
Minimum weight capacity	0 kg

Weight and Dimensions

Depth	435 mm
Width	660 mm
Height	585 mm
Weight	4620 g