39
40
Use Rain Cover
see images
38
To assemble the rain cover, place it over the stroller, and then
attach the 8 pairs of hook and loop fasteners on the rain
cover.
38
! Before using the rain cover, please make sure the backrest
has been adjusted to the lowest position and the infant child
restraint has been fastened.
! When using the rain cover, please always check its
ventilation.
! When not in use, please check that the rain cover has been
cleaned and dried before folding.
! Do not fold the stroller after assembling the rain cover.
! Do not place your child into the stroller assembled with rain
cover during hot weather.
Detach & Assemble Soft Goods
see images
39
-
50
1. Remove armbar cover shown as
39
2. Open the zipper which is on the rear panel of canopy.
40
! Adjust backrest to the lowest position to be convenient to
remove soft goods.
3. Remove calf support cover.
41
4. Open the buckle which is on the bottom of seat.
42
! Please keep support board well, must assemble support
board when assembling soft goods.
49
50
To re-assemble seat soft goods, follow the steps above in
reverse
50
-
39
Cleaning and Maintenance
see images
51
! To clean stroller frame, use only household soap and warm
water. No bleach or detergent. Please refer to the care label
for instructions on cleaning the fabric parts of the stroller.
! Removable soft goods can be washed by machine. No
bleach. Do not twist the seat cover and inner padding to dry
with great force. It may leave the seat cover and inner
padding with wrinkles.
! From time to time, check your stroller for loose screws, worn
parts,torn material or stitching. Replace or repair the parts as
needed. Periodically wipe clean plastic parts with a soft
damp cloth. Always dry the metal parts to prevent the
formation of rust if the stroller has come into contact with
water.
! Excessive exposure to sun or heat could cause fading or
warping of parts.
! If stroller becomes wet, open canopy and allow to dry
thoroughly before storing.
! If wheels squeak, use a light oil (e.g., Silicon Spray, antirust
oil, or sewing machine oil). It is important to get the oil into
the axle and wheel assembly.
51
! When using your stroller at the beach or other sandy/dusty
environments, completely clean your stroller after use to
remove sand and salt from mechanisms and wheel
assemblies.
To Next Page
Loading...
Need help?
General
