Joie nitro - Stroller Assembly; Open Stroller; Assemble Front Wheels; Assemble Rear Wheels

10
and out of the stroller.
! To avoid finger entrapment, use care when folding and unfolding the
stroller.
! Be sure the stroller is fully open or folded before allowing child near the
stroller.
! To ensure your child’s safety, please make sure all parts are assembled
and fastened properly before using the stroller.
! To avoid strangulation, do make sure your child is clear from the hood.
! Always engage the brakes when parking the stroller.
! Discontinue using stroller if it is damaged or broken.
! Stroller to be used only at walking speed. This product is not intended
for use while jogging.
! To avoid suffocation, remove plastic bag and packaging materials
before using this product. The plastic bag and packaging materials
should then be kept away from babies and children.
! This product is not suitable for running or skating.
! Pushchair designed to be used from birth shall recommend the use of
the most reclined position for new born babies.
! The parking device shall be engaged when placing and removing
children.
! WARNING To avoid injury ensure that the child is kept away when un-
folding and folding this product.
! Extra Care is needed if used on moving vehicles and child should not be
left unattended, even with brakes engaged.
Stroller Assembly
Please read all the instructions in this manual before assembling and using this product.
Open Stroller
Separate storage latch from storage mount
1
, and then lift the handle upwards
2
- 1 , push the foot plate
downwards with foot
2
- 2 , a click sound means the stroller is open completely.
! Check that the stroller is completely open before continuing.
Assemble Front Wheels
Assemble front wheels to front legs. Check that wheels are securely attached by pulling on wheel assemblies.
3
To disassemble front wheel, detach front wheel from front leg
4
- 2 while pressing the release tabs outwards.
4
- 1
Assemble Rear Wheels
Assemble rear wheels to rear legs
5
. Check that wheels are securely attached by pulling on wheel assemblies.
Snap the brake cable into the fixing tabs under square tubes to fix it.
6