11 12
8
2
1
9
1. Remove infant insert.
!
Vehicle waist belt must pass underneath
infant insert.
2. Pass the vehicle waist belt
8
- 1 through the
vehicle waist belt slots and then engage the
vehicle buckle tongue into the buckle.
9
3. Install the vehicle shoulder belt
8
-
2
in the
two rear-facing vehicle shoulder belt slots at the
back of the seat shell.
10
!
Vehicle shoulder belt must pass through the
rear-facing vehicle shoulder belt slots.
!
The locking clip is used only when the child
restraint is used in the rearward facing mode.
!
The locking clip will make the child restraint
safer.
!
Please replace the locking clip and string in
the bag when they are not in use.
4. Take the locking clip out of the bag.
11
5. While pressing the child restraint down firmly
into the vehicle seat
12
- 1﹐ pull the vehicle
shoulder belt to fasten the child restraint tightly
and securely
12
- 2.
!
The child restraint cannot be used if the
vehicle safety belt buckle (female buckle end)
is too long to anchor the child restraint
securely.
12
- 3
6. Press button to open the locking clip.
13
10
11
2
1
12
3
13
To Next Page
Loading...
Need help?
General
