Joie steadi - Cautions

20 21
EN EN
While pressing the child seat, pull the belts to fasten the child seat
tightly and securely.
24
!
Please check by moving the child seat back and forth.
!
Shoulder belt passes through Lock-off Device, confirm the Lock-off
Device is pushed down, as
23
!
The vehicle buckle tongue is engaged with the buckle correctly,
as
22
iv. Securing your Child in the child seat
see images
26
-
27
1. Place the child in the child seat and pass both arms through the
harnesses.
26
2. Pull down the adjustment webbing and adjust it to the proper length so
that your child is snugly secured.
27
!
Make sure the space between the child and the shoulder harness is
about the thickness of one hand.
for Head Support and Shoulder Harnesses
see images
28
1. Please adjust the head support and shoulder harnesses to proper
height according to the child's height.
2. Squeeze the head support adjustment lever
28
-1, meanwhile
pull up or push down the head support until it snaps into one of the
6 positions. The head support positions are shown as
28
1. When installing the child seat in the forward facing mode, DO NOT use
the small seat pad.
2. Please install the child seat on the vehicle seat, and then put the child in
the child seat.
3. After the child is placed into the child seat, check whether the shoulder
harnesses are at proper height.
Note
Cautions
!
After removing the foam of small seat pad, please store it somewhere that
the child can not access it.
!
Please wash the soft goods with cold water under 30°C.
!
Do not iron the soft goods.
!
Do not bleach or dry clean the soft goods.
!
Do not use undiluted neutral detergent, gasoline or other organic solvent to
wash the child seat. It may cause damage to the child seat.
!
Do not twist the soft goods to dry with great force. It may leave the soft
goods with wrinkles.
!
Please hang dry the soft goods in the shade.
!
Please remove the child seat from the vehicle seat if not in use for a long
period of time. Put the child seat in the shade and somewhere your child
can not access it.
Soft Goods Assembly
see images
29
-
34
1. Place the seat pad on the body and thread the buckle through the seat pad
slot.
29
2. Wrap the buckle with the crotch strap and stick the velcro.
3. Thread the adjustment webbing and harnesses on both sides through the
seat pad respectively.
30
4. Place the fastening pieces in top of seat pad into the two slots on the head
of the body.
31
5. Place the fastening pieces on sides of the seat pad into the four slots on
both sides of the body.
32
6. Assemble 2 pairs of elastic straps on both sides of head support.
33
7. Put the small seat pad into the child seat and engage the buckle.
12
The assembled soft goods are shown as
34
To assemble soft goods in reverse steps.