Joie verso - Combined Installation and Soft Goods; 3-Point Belt and ISOSAFE Combined Installation; Detaching Soft Goods from Restraint

19
20
b. For installation with 3-point-belt and ISOSAFE
1. Installation with ISOSAFE attachment is as
25
-
29
2. Place the child in the child restraint and check whether the shoulder belt
guides are at proper height.
3. Installation with 3-point-belt is show as
33
-
34
4. Correctly assembled 3-point-belt and ISOSAFE attachment is shown as
35
! Make sure that both ISOSAFE connectors are securely attached to their
ISOFIX attachment anchor points. The colors of the indicators on both
ISOSAFE connectors should be completely green.
35
-1
! Check to make sure the child restraint is securely installed by pulling on
both ISOSAFE connectors.
! Shoulder belt must pass through shoulder belt guide.
35
-3
! Waist belt must pass through lap belt guides.
! The child restraint can not be used if the vehicle safety belt buckle
(female buckle end) is too long to anchor the child restraint securely.
35
-2
! Never use a vehicle waist-only belt across front of child.
! Do not use shoulder belt loose or positioned under arm.
! Do not use shoulder belt behind child’s back.
! Do not allow child to slide down in the child restraint in case of strangulation.
35
3
1
2
Detach Soft Goods
see images
36
-
44
1. Press the red button to disengage the buckle.
! To assemble soft goods, reverse the steps above.
36
38
39
37