EasyManua.ls Logo

JoinTech JT600 - 5.3 LED Indications; 5.4 Configure by PC setup software

JoinTech JT600
40 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
- 11 -
5.3 LED Indications
LED
Status
Note
CH LED(RED)
On
Charging
Turn Green
The battery is full
Off
No charging
POW LED
(yellow)
Blinking
Low Battery. You need to charge the unit.
GSM
LED(Green)
Blinking every 5 seconds
JT600 got GSM signal.
Blinking every 1 seconds
JT600 didnt get GSM signal Or Didnt plug SIM card
Blinking 10 times in one
second(Very fast)
GPRS connected, Data uploading to center server.
GPS LED(Blue)
Blinking every 10 seconds
GPS signal is valid
Blinking every 3 seconds
GPS signal is invalid
Off
GPS module Power off
Flashlight
LED(White)
On
Flashlight
Thrice long and short
circulating continuously
SOS
Off
Normal
Note: All LEDs will be off if the tracker goes to sleep mode.
(Table 3)
5.4 Configure by PC setup software
Refer to the manualJT600 Mini-USB Cable Driver InstallationV1.2.pdf,Install the Mini-USB cable driver, and
plug it to PC. Copy JT600 Assistant V3.1 software to your PC and Open it.