19
2020
Assemble Canopy
To assemble canopy, insert clips into mount, then attach 2 pairs of but-
tons.
11
i. Engage the canopy webbing with recline buttons first.
11
- 1
ii. Then engage the softgood with canopy webbing and buttons.
11
- 2
The completely assembled stroller is shown as
12
Stroller Operation
Use Canopy
Open the zipper, then push the canopy forwards to open the canopy.
13
! Please adjust the backrest to upright position before opening the
canopy if it is convenient.
14
! Please press the backrest before opening the canopy if it is not conve-
nient to adjust the backrest to upright position.
15
To fold the canopy, pull canopy toward back.
To remove canopy, detach clips from mount while pressing the fixing tab
16
, then detach 2 pairs of buttons (used to attach the canopy fabric to the
seat) now lift of the canopy.
11
! Once fitted, removing the canopy on a regular basis is not recom-
mended.
Switch Seat
The seat can be switched, which makes mother and child can face to face
with each.
Squeeze the seat release buttons while lifting the seat.
17
Turn the seat to
reverse direction, and then insert the seat to seat mounts.
18
Adjust Recline
There are 5 positions for the backrest.
To recline the backrest, squeeze the adjustment button
19
- 1, and then
adjust the backrest to a desired angle.
19
- 2 To raise the backrest, push
up.
! Make sure the recline is set properly for use.
Use Buckle
Release Buckle
Press the center button to release the buckle.
20
Lock Buckle
Match the waist belt buckle with the shoulder buckle
21
- 1, and click into
the center buckle.
21
- 2 A “click” sound means the buckle is locked
completely.
21
- 3
! To avoid serious injury from falling or sliding out, always secure your
child with harness.
! Make sure your child is snugly secured. The space between the child
and the shoulder harness is about the thickness of one hand.
! Do not cross the shoulder belts. This will cause pressure on child’s
neck.
Use Shoulder & Waist Harnesses
! In order to protect your child from falling out, after your child is placed
into the seat, check whether the shoulder and waist harnesses are at
proper height and length.
22
- 1 Shoulder harness anchor A
22
- 2 Shoulder harness anchor B
22
- 3 Slide adjuster
For larger child, use shoulder harness anchor A and the highest shoulder
slots. For smaller child, use shoulder harness anchor B and the lowest
shoulder slots.
To adjust the position of the shoulder harness anchor, turn the anchor to
be level with the side facing forward. Thread it through the shoulder
harness slot from back to front.
23
Rethread it through the slot that is
closest to child's shoulder height.
24
To Next Page
Loading...
General