- 12 -
ATTENTION
When clearing always wear rubber gloves
EN
INDUSTRIAL GLASS AND DISHWASHER—USERS MANUAL
WASH / RINSE ARMS - ROTATING TYPE
1. Unscrew the centre spindle and lift the wash arm out.
2. Unscrew the nuts (A1-A2) and remove the jets (B1-B2).
3. Immerse the jets in a solution containing some liquid descaling product (example: Vinegar)
4. Rinse with water. If necessary, clean the jets with a pin.
5. Check that there are no scale deposits on the arm or spindle.
6. Reverse the assembly.
7. It is suggested to wash and clean jets (B1) individually in order to avoid an incorrect assembly.
DIAGRAM OF THE CORRECT POSITION OF THE JETS
To Next Page
Loading...