Faucet Installation
®
You will need to use or drill a 1 ⁄” (35mm) diameter hole
in the counter-top or sink where you would like to place
the faucet.
DRILL 1⁄” (35MM )HOLE FOR FAUCET
Fold base clamping plate to allow it to pass through the 1⁄”
(35mm) diameter hole and locate the O-ring seal under the
base assembly.
Insert base clamp assembly thought the 1⁄” (35mm)
diameter hole, and pull up on “tabs” to draw the clamping
plate into position under the bench.
Rotate the base assembly to the correct orientation as
illustrated so that the dispenser’s faucet handle will face the
correct way once installed.
Base clamp
Draw tabs
INSTALLING FAUCET BASE ASSEMBLY
Set screw and Allen key
Faucet base O-ring
Base assembly clamping screws
Faucet base and clamp assembly
FAUCET FITTING KIT FOR DISPENSER
IMPORTANT
IMPORTANT
To Next Page
Need help?
General
