JONR ED10 - Installation Guide; Handle Assembly and Disassembly

7
Installation
Handle Disassembly
Click
To remove the aluminum tube of the handle,
insert a long, thin, and rigid object into the hole
in the back of the body to press the elastic sheet
while pulling the machine handle upwards.
Insert the end of the aluminum tube vertically
into the hole on the host until a “click” sound is
heard, and make sure that the tube is tightly
inserted, indicating that it is installed
successfully.
Insert the end of the handle
vertically into the bore of the
aluminum tube until a “click”
sound is heard, and make sure that
the handle is tightly inserted,
indicating that it is installed
successfully.