Jonsered 435e - Table of Contents; Contents

CONTENTS
8 – English
1153135-26 Rev .1 2009-12-29
Contents
KEY TO SYMBOLS
Symbols on the machine: ...................................... 7
Symbols in the operator’s manual: ........................ 7
CONTENTS
Contents ............................................................... 8
INTR ODUCTION
Dear Customer , ..................................................... 9
WHA T IS WHAT?
What is what on the chain sa w? ........................... 9
GENERAL SAFETY PRECA UTIONS
Bef ore using a new chain saw .............................. 10
Important .............................................................. 10
Always use common sense .................................. 11
Personal protective equipment ............................. 11
Machine ′ s safety equipment ................................. 11
Cutting equipment ................................................. 13
ASSEMBL Y
Fitting the bar and chain ....................................... 17
FUEL HANDLING
Fuel ....................................................................... 18
Fuelling ................................................................. 19
Fuel safety ............................................................ 19
ST AR
TING AND STOPPING
Star ting and stopping ............................................ 20
W ORKING TECHNIQUES
Bef ore use: ............................................................ 21
General working instructions ................................ 21
How to avoid kickback ........................................... 24
MAINTENANCE
Gener al ................................................................. 25
Carburettor adjustment ......................................... 25
Checking, maintaining and servicing chain saw
saf
ety equipment .................................................. 25
Muffler ................................................................... 26
Starter ................................................................... 26
Air filter .................................................................. 27
Spark plug ............................................................. 27
Lubricating the bar tip sprocket ............................. 27
Needle bearing lubrication .................................... 27
Cooling system ..................................................... 28
”Air Injection” centrifugal cleaning ......................... 28
Winter use ............................................................. 28
Maintenance schedule .......................................... 29
TECHNICAL D ATA
T echnical data ....................................................... 30
Bar and chain combinations ................................. 31
Saw chain filing and file gauges ........................... 31
EC-declaration of conformity ................................ 31