20
English
INSTALLATION
Cleaning liquid tank
Mount the cleaning liquid tank on the right-hand
support beam of the saw carriage and connect
spiral hose.
Fuel tank
Mount the fuel tank on the saw carriage as
follows:
1. Secure the tank by means of screws on the
left-hand support beam of the saw carriage.
2. Connect the fuel line from the tank to the
motor.
Steering handle
Mount the steering handle on the left-hand
support beam and tighten the screws to a torque
of 5 Nm.
Allow 1 mm of play at the motor throttle control.
Position the steering handle in a suitable height.
Make sure that the wires are running easily.
1 mm
5 Nm
To Next Page
Loading...