English – 21
ASSEMBLY
Adjusting the harness and clearing
saw
Quick release
On the front is an easily
accessible, quick release
catch. This is activated by
pulling the outer part of the
chest plate straight out. Use
this if the engine should
catch fire or in any other
emergency situation when
you quickly need to take off
the harness and machine.
Even load on the
shoulders
A well-adjusted harness and
clearing saw significantly
facilitates working. Adjust
the harness for the best
working position. Tension
the side straps so that the
weight is evenly distributed
across the shoulders.
Correct height
1) Forestry clearing
Adjust the carrier strap so
that the suspension hook
comes approximately 10
cm under the hip. The
blade should be angled
forward a little.
2)Grass clearing
The suspension hook
should hang approximately
20 cm under the hip so
that the blade is parallel to
the ground.
Correct balance
1)Forestry clearing
Move the suspension eye
forwards or backwards. If
the blade is balanced a 10-
20 cm above the ground it
is easier to avoid stones.
2)Grass and brush cutting.
Let the blade balance at a
comfortable clearing
height, i.e. close to the
ground.
WARNING!
When working with the clearing saw it
should always be hooked in the harness.
If this is not done, you cannot control the
clearing saw safely and this can result in
injury to yourself or someone else. Never
use a harness with a defective quick
release catch.
!
To Next Page
Loading...
Need help?
General
