To Next PageTo Next Page
Need help?Do you have a question about the Jonsered LM 2155MD and is the answer not in the manual?
General| Engine Manufacturer | Briggs & Stratton |
|---|---|
| Cutting Height Adjustment | Central |
| Cutting Height Min | 25 mm |
| Cutting Height Max | 75 mm |
| Side Discharge | Yes |
| Drive System | Self-propelled |
Read instructions, be familiar with controls, and ensure proper use of equipment.
Inspect area, remove objects, wear appropriate footwear, and handle fuel safely.
Mow in daylight, avoid wet grass, maintain footing on slopes, and never operate with guards removed.
Stop blade when tilting, ensure guards are in place, avoid changing governor settings.
Stop engine and disconnect spark plug wire for cleaning or checks. Stop engine when leaving or refuelling.
Learn and understand the meaning of symbols appearing on the machine or literature.
Complies with provisions and current amendments of relevant Directives and Standards.
Identifies main parts of the Jonsered LM 2155MD lawnmower using numbered labels.
Instructions for pulling up the handle and tightening wing-nuts.
Steps to install the starter rope, including loosening and tightening the T-knob.
Instructions on how to set up the mower for mulching or discharging.
How to set different cutting levels by adjusting the lever at each wheel.
Instructions for filling the engine with the correct oil type and level.
Procedure for safely starting and stopping the lawnmower using the brake yoke.
How to engage and disengage the mower's forward drive using the clutch bar.
Do not use on slopes exceeding 15 degrees to avoid engine lubrication problems.
Remove objects like twigs, toys, and stones from the lawn before mowing.
Mow twice weekly during peak growth, never cut more than 1/3 of grass length.
Always remove spark plug lead before work. Tighten screws and check oil after 5 hours.
Stop engine, unscrew dipstick, and check oil level is between FULL and ADD.
Instructions for removing, sharpening, and balancing the cutter blade.
Procedure for changing engine oil, including draining fuel and warming engine.
Steps to clean or replace the air filter for optimal engine performance.
Remove spark plug lead, empty fuel tank and oil before public transport.
