20
USER GUIDE HOTTAP
21
O Grid Plumbing :
Setting up & Use
1. Remove the red plugs
from the inlet and outlet of
the pump.
5. Plug the lighter port
cable into the pump and
connect to power.
6. Press the power button
on the pump, leaving it
in the “on” position. You
can now start and stop
the pump (as well as the
Hottap) simply by icking
the switch on the shower
or faucet handle.
3. Set up your lter for
intended use - i.e. with or
without the intake collar -
and attach to end of pump
inlet hose. Drop or throw
lter into water source.
2. Snap the hoses onto the
quick-connect ttings on
the water inlet and outlet.
4. Observing the ow
direction of the pump,
attach the pump outlet
hose to the blue
quick-connect tting on
the Hottap.
great for water sources
with narrow openings
(like your jerry can)
intake collar
the intake
collar raises
the lter o
the ground
To Next Page
Loading...
Need help?
General
