JOOLCA Hottap User Manual

30
USER GUIDE HOTTAP
31
Safety instructions
GENERAL WARNINGS
This appliance shall only be used
with the Australian Approved
1200mm ULPG gas hose and
regulator assembly supplied
with the appliance and must
be connected only to an ULPG
gas cylinder certied to AS2469
standards tted with POL
connections only.
IT MAY BE HAZARDOUS TO
ATTEMPT TO FIT OTHER TYPES
OF GAS CONTAINERS
This appliance is to be stored in
a dry and well-ventilated location
free from direct sunlight. Do not
store when still connected to
the cylinder. Make sure that the
cylinder is disconnected and is
stored in a well-ventilated area,
free from direct sunlight, heat
and ignition sources and out of
reach of children. If being stored
indoors, ensure that the location
complies with the standard AS/
NZS1596.
This appliance must only be
serviced by an authorized service
agent, return to your place of
purchase for service and repair.
DANGER!
• This appliance is designed for
outdoor use only.
• Use only in well
ventilated areas.
• Do not use this appliance if it
has damaged or worn seals.
• Do not use this appliance if it is
leaking, damaged, or does not
operate properly.
• CAUTION:
Accessible parts may be very
hot. Keep young children away.
• USE OUTDOORS ONLY
• This appliance shall only be
used in an above ground
open-air situation with natural
ventilation, without stagnant
areas, where gas leakage and
products of combustion are
rapidly dispersed by wind and
natural convection.
• Do not use adaptors or modify
the appliance to t other
connectors or cylinders.
• When using this appliance,
children must be supervised by
an adult at all times.
• Never leave the appliance
unattended when operating.
• Do not use as cooking
appliance or modify for any
other reason.
CARBON MONOXIDE HAZARD
ONLY USE IN WELL-
VENTILATED AREAS. CARBON
MONOXIDE HAZARD - USING
THIS APPLIANCE IN AN
ENCLOSED SPACE MAY
CAUSE DEATH. DO NOT USE
IN CARAVANS, TENTS, MARINE
CRAFT, CARS, MOBILE HOMES
OR SIMILAR LOCATIONS.
IMPORTANT
• Avoid twisting and kinking the
ULPG Gas hose.
• If there is a leak on your
appliance (smell of gas),
immediately attempt to turn o
the cylinder valve. Remove the
appliance to a well-ventilated
location away from any ignition
source. Check for leaks using
soapy water. Do not try to
detect leaks using a ame.
• Do not attempt to move or
relocate the appliance when it
is operating.
• Extinguish the burner and
allow to cool. Disengage the
gas cylinder then move
the appliance.
Check for gas leaks
• Check that seals between the
appliance and the gas container
are in place and in good
condition before connecting
the gas container.
• Only use the hose assembly as
supplied with this appliance for
connection to the cylinder –
Do not use adaptors
• Check that all connections are
tight and that the gas cylinder
connection has been tightened
before you turn the cylinder gas
valve on.
Never check for leaks with a
ame or pilot light.
• Using soapy water, coat all
connections. If bubbles appear
turn the cylinder gas control o
and re-tighten the connection
before re-testing.
• Inspect the appliance regularly
for signs of wear, leaks or
incorrect operation. If symptoms
such as aring of the burners,
issues with lighting, damage
to hoses or connections or
leaks from seals or gas controls
are identied do not attempt
to repair, contact the Joolca
Customer Support team.
• To check there is still gas in
the cylinder, disconnect from
the appliance and hold the
cylinder in a vertical position
and shake from side to side.
If there is a sound or liquid
movement inside, the cylinder
contains gas.
• When changing gas cylinders
ensure this is conducted
outside in a well-ventilated
location free from people,
animals and ignition sources
such as naked ames, pilot
lights and electrical equipment
such as heaters or elements.

JOOLCA Hottap Specifications

General

Brand	JOOLCA
Model	Hottap
Category	Laboratory Equipment
Language	English