!
5) Once you determine that there are no
leaks present with the gas valve open, turn
the cylinder valve to the off (close) position.
6) Take the second washer from earlier and
place it inside the threaded fitting on the
loose end of the shower nozzle hose. Attach
this fitting to the ‘water outlet’ connection.
You may use Teflon tape to avoid leaks.
7) Prepare a garden hose with a ‘quick
fitting’ plug and attach is to the male garden
hose fitting already installed on the ‘water
inlet’ pipe.
This appliance is also compatible with other
forms of water supply including low voltage
water pumps. For information on how to
connect to this please consult your pump
accessory instruction manual or contact
customer service on 1300 669 500.
Our heater is now set up and ready for use.
Notice: the positioning of the gas cylinder
away and to the side of the appliance; never
place the gas cylinder directly beside or
above the appliance.
8) Ensure that the flow regulation switch on
the shower nozzle handle is in the ‘off’
position.
To Next Page
Loading...
Need help?
General
