!
OPERATING THE APPLIANCE
Now that the appliance has been prepared
with the proper adapter fittings
and connections for our intended use (with
a garden hose water supply) we can set it
up for operation.
To use with other water input sources such
as a low voltage pump, please consult the
pump instruction manual or call customer
service on 1300 669 500 for advice.
1) Find a suitable sturdy, non-combustible
vertical surface to hang the appliance. The
surface should be at least 500mm clear
from the sides and 1000mm from the top
of all combustible surfaces, fabrics,
flammable materials & people.
Hang the appliance on a suitable vertical
surface by the top tab attached to the
back cover of the heater.
The appliance is ready to be connected to
gas and water hoses.
Note: that there is also a bottom tab
available to hang the appliance from if
needed.
2) Attach the flexible hose and regulator
to the ‘gas inlet’. Tighten this connection
with a spanner, taking care not to over
tighten as doing so may damage the pipe.
3) Connect the other end of the flexible
hose and gas regulator to the POL Propane
gas cylinder. Hand-tighten the connection in
an anti- clockwise direction.
4) Turn the gas cylinder on (open) in an
anti-clockwise direction one full turn, and
then check the connections for leaks with
soapy water. DO NOT use a flame. If a
leak is detected, turn the cylinder valve off
(close) and retighten all connections and
retest.
To Next Page
Loading...
Need help?
General
