Page 4
Doll or Stuffed Toy Booster Seat Instruction Manual
Using your Doll Booster Seat in the
Vehicle
Vehicle Seat Requirements
• The doll booster should be placed in the center position of the seat directly
behind the front seats whenever possible. This is the same location that a
real booster would be placed.
• The vehicle seat should always be a forward facing seat and the seat should
lock in an upright position.
WARNINGS
• NEVER use this toy to carry a baby or child for any purpose whatsoever.
• DO NOT use the booster to carry any dolls or stuffed toys that weigh more than
7 pounds.
• As with a real booster, this toy booster should never be placed near the edges
of counter tops, tables, or other elevated surfaces.
• Bring the seat belt around the doll’s waist and insert the male end of each waist
strap buckle into the female buckle. Insure that they snap into place. See
Figure 3. Tighten the waist belt to be snug around the doll’s waist.
• Buckle the harness clip pieces together. See Figure 4.
Position the harness clip in the middle of the doll or stuffed toys’
chest, level with the armpits and away from the neck.
• Both the shoulder straps and the waist straps may be adjusted using
the sliding buckle on these straps, located on the back of the booster.
See Figure 5.
Figure 5Figure 4Figure 3
To Next Page
Loading...
Need help?
General