Doll or Stuffed Toy Booster Seat Instruction Manual
Page 7
Unacceptable Vehicle Belt Systems
DO NOT use any of the following systems to secure the doll booster.
• Lap Belts with Emergency Locking Retractor (ELR): This lap belt stays
loose and can move until it locks in a sudden stop or crash.
• Combination Lap/Shoulder Belt with Retractor: Each strap has a retractor
at one end and is attached to the latch plate at the other end.
• Passive Restraint-Lap or Shoulder Belt Mounted on Door
• Passive Restraint-Lap Belt with Motorized Shoulder Belt
• Lap Belts Installed Forward of Seat Crease
Installing Doll Booster Seat with LATCH
• Extend LATCH Attachment Strap to its maximum length.
• Place the booster in a front-facing position in the vehicle seat.
• Thread LATCH Attachment Strap through one of the slots on the side of the
booster and then out the other side slot. See Figure 9. Make sure strap lays
flat and is not twisted.
• Push the connectors through the seat crease slots and hook them to vehicle
lower anchors. See Figure 10. Pull firmly on connectors to be sure they are
attached.
• Tighten LATCH by pushing down hard on booster and pulling the adjustment
belt.
• NEVER put two LATCH Attachment Strap connectors on one vehicle LATCH
anchor unless specifically allowed by the vehicle manufacturer.
• Check that the LATCH Attachment Strap stays tight and does not slip from
the tightened position. If it does, try another seating position or contact our
Customer Service Department at (877) 456-5049 for assistance.
Figure 9 Figure 10
To Next Page
Loading...
Need help?
General