9
Using the Rear Bench Seat
• Push the bench seat to its most rearward position.
NOTE: There are webbing straps attached to the bottom of the rear seat pad. These straps will
lock the seat into the most rearward position. To lock the seat, pull the straps from EACH side of
the pad and loop them around the frame as shown, then snap them together. (26)
• To slide the seat forward, undo EACH snap and reattach the webbing to the underside of the seat
pad using the Velcro® attachments.
• Position the canopy to its most forward position.
• To unlatch the buckle press the center button and remove both latch posts.
• Have the child sit on the bench seat facing backward with their feet on the platform.
• You may need to adjust the recline position of the front seat to allow for more room for the child to
sit.
• Place the crotch strap between the child’s legs.
• Push the waist latch posts into the crotch buckle until all parts snap into place. (27)
• Adjust the waist straps to be snug around the child’s waist.
• Be sure that BOTH of the child’s feet are fully on the platform at all times.
• Be sure that BOTH of the child’s hands are holding the frame.
IWARNING: NEVER allow a rear seated child to use the
canopy as a hand hold.
Storage Basket
The maximum weight that can be carried in the storage basket is 15 lbs. (6.8 kg).
Parent Organizer
• Loop one strap of the parent organizer around one side of the handlebar and loop the rest of the
strap back around the handlebar to attach the Velcro®. (28)
• Repeat for the other side. Ensure the parent organizer is secure.
IWARNING: For use ONLY on the Joovy Big Caboose
Stroller. NEVER carry hot beverages or open containers in this product.
Maximum weight for Organizer is 5 lbs. (2.3 kg).
Using the Stroller with Infant Car Seats
These steps are for BOTH front facing seats. The Joovy Big Caboose will accommodate a car
seat in EACH of the front seats.
NOTE: See insert for a list of specic compatible car seat models.
• Remove the front tray and the front canopy. Install the infant car seat adapter in the front tray
mounts. Ensure it is secure on BOTH sides. (29)
• ADJUST THE SEAT TO ITS RECLINE POSITION.
• Remove the infant car seat from its base and place it onto the front seat of the stroller so it is in a
REAR FACING POSITION. Position the “head” end toward the front, resting on the infant car seat
adapter. Position the “feet” end on the seatback - but NOT on the top edge of the seatback. (30)
• Buckle the restraining straps over the LOWEST part of the infant car seat (the straps are located in
the pockets on the side of the seat). Adjust the straps so they are tight around the infant car seat
but AWAY from the child’s neck. Pull up on the infant car seat to be sure it is secure. (31)
• To remove the infant car seat from the stroller, unlock the restraining strap buckle by pressing the
button and both side releases. (32)
• Return the restraining straps to their pockets.
To Next Page
Loading...
Need help?
General
