10
IWARNING: ALWAYS install the infant car seat so that the
child is facing toward the rear (handle) of the stroller with the restraining
straps secured. ALWAYS position the infant car seat so that it is securely
placed down inside the infant car seat adapter frame. ALWAYS position
the infant car seat so that it is resting ON the seatback, but NOT on the
top of the seatback. The seatback must be in the RECLINE position.
NEVER position the restraining straps on or near the child’s neck as this
may result in strangulation. The infant car seat adapter is for use ONLY
with specic infant car seat models. See insert for specic models.
DO NOT use other infant car seat models.
Folding the Stroller
• Keep children away from stroller while folding.
• Remove any infant car seat. The stroller can be folded with the infant car seat adapter in place.
• Close BOTH canopies and push it forward.
• Put the front seats into there most upright position.
• Make sure both rear wheel brakes are set to their locked positions.
• Lock BOTH front wheel sets in place with locking levers facing forward.
• Unlock the safety latches on the BOTH sides of the stroller.
• Pull upward on the trigger mechanisms on both sides of the stroller and push the handle fully
forward. (33)
CAUTION: While folding the stroller, be careful to keep your ngers from being pinched by moving
parts.
• Engage the fold lock on the right side of the stroller over the mounting post. (34)
IWARNING: ALWAYS keep children away from the stroller
when folding. Possible pinching hazard – Be careful when folding the
stroller.
To Next Page
Loading...
Need help?
General
