jotron RA-7203C User Manual

jotron RA-7203C Specifications

General

Brand	jotron
Model	RA-7203C
Category	Radio
Language	English

Summary

SAFETY INSTRUCTIONS

Electrical Hazard Warning

Introduction

Technical SPECIFICATIONS

2.1 General Specification, Transceiver Units, TR-7750C

Provides overall technical specifications, standards, and environmental data for the TR-7750C.

2.2 Transmitter Units, TA-7650C

Lists detailed technical specifications for the TA-7650C transmitter unit.

2.3 Receiver Unit, RA-7203C

Details the technical specifications for the RA-7203C receiver unit.

Functional description

3.1 Front Panel Controls, Transmitter Unit

3.2 Transmitter, Rear Connections

3.3 Front Panel Controls, Receiver Unit

3.4 Receiver, Rear Connections

Installation

4.6.1 REM Connector (Receiver) and RX Connector (Transmitter)

4.6.2 Audio in/out and Line loop keying

4.7.3 Transmitter, Main / Backup Configuration

Describes how to set up main and backup transmitter units for redundancy.

4.7.4 Receiver, Main / Backup Configuration

Details setting up main and backup receiver units for redundancy.

Operating Instructions

5.4 Setting, Information and Configuration Menus – Transmitter

5.4.1 Radio Control Group (Transmitter)

5.4.2 TX Config Group (Transmitter)

Details parameters for FM operation, audio, keying, and calibration.

5.4.3 Interface Config Group (Transmitter)

Covers access control, language, RS485, RS232, and LAN configurations.

5.4.4 Bite System Group (Transmitter)

5.5 Parameter Details – Transmitter

Provides detailed explanations of transmitter parameters within Radio control, TX config, Interface config, and Bite system groups.

5.5.1 Radio Control Group (Transmitter)

Details specific parameters for radio operation mode, power, modulation, and alarms.

5.5.2 TX Config Group (Transmitter)

Explains specific parameters for transmitter configuration like output power and modulation.

5.5.3 Interface Config Group (Transmitter)

Details parameters for access control, language, RS485, RS232, and LAN settings.

5.5.4 Bite System Group (Transmitter)

Lists bite system measurements for transmitter diagnostics like power, voltage, and temperature.

5.8 Setting, Information and Configuration Menus – Receiver

5.8.1 Radio Control Group (Receiver)

5.8.2 RX Config Group (Receiver)

Details parameters for FM operation, audio, squelch, and calibration for the receiver.

5.8.3 Interface Config Group (Receiver)

5.8.4 Bite System Group (Receiver)

5.9 Parameter Details – Receiver

Provides detailed explanations of receiver parameters within Radio control, RX config, and Bite system groups.

5.9.1 Radio Control Group (Receiver)

Details specific parameters for receiver operation mode, squelch, modulation, and alarms.

5.9.2 RX Config Group (Receiver)

Explains specific parameters for receiver configuration like audio output and squelch settings.

5.9.4 Bite System Group (Receiver)

ERROR CONDITIONS AND CORRECTIVE ACTIONS

6.1 Transmitter Error Conditions

Identifies common error conditions and corrective actions for the transmitter unit.

6.2 Receiver Error Conditions

Identifies common error conditions and corrective actions for the receiver unit.