Jøtul F 118 CB - Standards; Codes

4
Standards
The Jøtul F 118 woodstove has been tested and listed to:
U.S: ANSI/UL 1482 and ANSI/UL 737
Canada: CAN/ULC-S627-M93
Tests performed by:
ITS, Intertek Testing Services
Middleton, WI
Manufactured by:
Jøtul AS, P.O. Box 1411, Fredrikstad, Norway
Distributed by:
Jøtul North America
55 Hutcherson Drive
Gorham, Maine 04038-2644
The Jøtul F 118 meets the U.S. Environment Protection
Agency’s Emissions limits for wood heaters manufactured
and sold after July 1, 1990.
Under specific laboratory test conditions, this heater has
shown heat output at rates ranging from 12,000 to 23,500
BTU’s per hour. Actual heat output will vary depending
upon fuel type and quality, home design, climate,
environment, operation, and chimney function.
The Jøtul F 118 woodstove is only listed to burn solid wood
only. Do not burn any other fuels.
Read this entire manual before you install and use your
new Jøtul F 118 wood stove.
Save these instructions and make them available to
anyone using or servicing the stove.
Check Building Codes
When installing, operating and maintaining your
Jøtul F 118 woodstove, follow the guidelines presented
in these instructions, and make them available to
anyone using or servicing the stove.
Your city, town, county or province may require a building
permit to install a solid fuel burning appliance.
In the U.S., the National Fire Protection Association’s
Code, NFPA 211, Standards for Chimneys, Fireplaces, Vents
and Solid Fuel Burning Appliances, or similar regulations,
may apply to the installation of a solid fuel burning
appliance in your area.
In Canada, the guideline is established by the CSA
Standard, CAN/CSA-B365-M93, Installation Code for
Solid-Fuel-Burning Appliances and Equipment.
Always consult your local building inspector or
authority having jurisdiction to determine what
regulations apply in your area.
Installation and Operation Instructions for USA/Canada
Installation et fonctionnement pour Canada
Safety notice: If this solid fuel room heater is not properly installed, a house fire may result. For your
safety, follow the installation directions. Contact local building or fire officials about restrictions
and installation inspection requirements in your area. Save these instructions for future reference.
Avis de sécurité: Une installation non appropriée de ce poêle de chauffage risque de
provoquer un incendie. Assurez votre sécurité en respectant les directives d’installation
suivantes. Consultez les autorités locales du bâtiment ou de la prévention des incendies au
sujet des restrictions et exigences relatives aux inspections d’installations dans votre région.
USA/Canada
Tools Required:
• Measuring Tape • Work Gloves
• 10 mm open-end • Safety Glasses
or socket wrench • Tin snips
• 3 mm hex key • Phillips Screwdriver
Accepted For Use
City of New York
Department of Buildings
MEA 429-07-E
Jøtul North America, Inc.