21
Replacing the burn plate
Fig. 34
2. Remove the burn plate (C) by unscrewing the screw (D) in the
centre of the fi xing plate. Lift it up and tilt the burn plate out.
Replacing the exhaust defl ectors
Fig. 35
E
F
3. The lower and upper exhaust defl ectors are located above
the baffl e plate. Remove the lower defl ector (E) by lifting it
at the rear edge and tilting it out.
4. Lift the upper defl ector (F) out of the grooves and remove
it from the burn chamber.
When refi tting, follow the same procedure in reverse
order.
7.2 Replacing the burn plate/inner
bottom and fi re grate
(If using tools, it is important that the Skamol panel is handled
with care to avoid damage).
Fig. 36
G
1. Lift the baffl e plate and turn the key (fi g. 33 B) 90° in the
baffl e plate (fi g. 33 A) and then remove the key. Lift the
rear edge of the baffl e plate (G) and tilt it out.
2. Remove the burn plate (fi g. 33 C) by unscrewing the screw
(fi g. 33 D) in the centre of the fi xing plate. Lift the burn
plate and tilt it out.
3. Remove the fi re grate (fi g. 36 G).
ENGLISH
To Next Page
Loading...
Need help?
General
