3DMS1.1 / DM1.1 / DML1.1 Proportional Actuators
Wiring
Wiring Diagrams
Figure 4: Proportional Control
Figure 5: Signal data
(1) Signal
(2) Potentiometer
(3) Adapting
Figure 6: Parallel connection
Figure 7: Auxiliary switches
(1) Auxiliary switch factory set at 10° CW
(2) Auxiliary switch factory set at 80° CW
(3) Actuator at 0°position
WARNING:
• The electrical connections for the actuators must be
executed in accordance with the relevant legal requirements.
• In order to avoid any personal injury or damage to the
equipment or other property, always isolate the power
supply before commencing any work on the electrical
wiring.
• In order to avoid danger to property, it is important for the
equipment to be used solely for which it is intended.
WARNING: The integrated circuits in the actuator are
sensitive to static electricity. Take suitable precautions.
To Next Page
Loading...
Need help?
General