If you start programming the Joy-IT
ARD_Mega2560R3, you have to install a deve-
lopment environment and the drivers for the
associated operating system on your compu-
ter which is going to be used for program-
ming.
The recommended development environ-
ment is the “Arduino IDE“ which is released
by the Arduino manufacturer as an open
source soware. This soware is aimed at
beginners, due to concept and structure. It is
compatible to the Joy-IT ARD_Mega2560R3
and has next to the development environ-
ment also the required drivers which make it
possible to start immediately.
The download for this soware can be found
with the following link:
https://www.arduino.cc/en/Main/Soware
3. SOFTWARE-INSTALLATION
To Next Page
Loading...
Need help?
General
