2. Inspect unit and assembly for any visible signs of d;mage hat
could have occured in shipment or during installation.
3. Fill sump to center line of fill fitting with oil as specified in
Oil Specifications Page 8. If sump is over-filled, drain to
proper level.
NOTE
TIGHTEN FILL FITTING PLUG SECURELY.
REMEMBER THIS IS A PRESSURIZED VESSEL.
4. Reconnect main disconnect switch.
CAUTION
JOG COMPRESSOR ‘TO CHECK FOR PROPER DIREC.
TION OF ROTATION AS INDICATED BY DIREC-
TION ARROW ON DISCHARGE END BEARING CAP.
IF DIRECTION OF ROTATION IS WRONG, COR-
RECT BY RE-CONNECTING THE MOTOR LEADS
TO OBTAIN PROPER ROTATION DIRECTION.
5. Close receiver discharge valve and move selector switch to
desired operating position. Constant speed setting is recom-
mended for initial start-up.
6, With receiver discharge valve closed, let machine pump
Up
to operating pl essure;
at this stage the automatic controls
will take over.
7. Open receiver discharge valve.
8. After unit has run for several minutes, shut it down and
check oil level. It may be necessary to add oil to compensate
for the amount of oil needed to fill the entire system.
NOTE
NO BREAK-IN PERIOD IS REQUIRED. THE MA-
CHINE CAN BE PUT IN FULL OPERATION IM-
MEDIATELY.
EMERGENCY SHUT-DOWN
To manually shut down the compressor in case of an emergency,
put selector switch located on electrical Control Center to “off”
position.
RESTART AFTER POWER FAILURE
If unit shuts down due to power failure, first check for blown
fuse then restart by resetting starter button.
15
To Next Page
Loading...
Need help?
General
