Joyor S5 - Function Menu and Parameter Settings

14 15
ENEN
switchtoP09:pressorto0.
Note: The system default is 1 (non zero startups). After
startup, it defaults to gear 0. In order to ride safely, please
confirm to start in gear 1. Then press down the acceleration
handle while sliding with your feet to start riding.
P12: Strength setting
Range:0to5.Afterenteringthesettinginterface,then
presstoswitchtoP12:pressortoselectthe
strength(Default:5).
P15: Motor drive signal percentage
Range:1to100.Afterenteringthesettinginterface,then
presstoswitchtoP15:pressortoselectthe
percentage(Default:100).
P16: Enable cruise
Afterenteringthesettinginterface,thenpressto
switchtoP16:pressortoselect0(OFF)or1(ON).
Afterstartingcruise,presstheaccelerationhandleuntilthe
cruiseiconlightsup.Atthistime,releasingthehandlewill
notstoptheassistance.Whenshiftinggears,brakingor
pressingtheaccelerationhandleagain,youwillexitcruise.
P99: Restore to initial settings
Enterthemenu,shortpresstheorkey,thevalue
00099ashes,andthedisplayreturnstothemaininterface
afterlong-pressingthekeyfor5seconds,thesettingis
successfullydone.
Pressandfor3Stoenterthesettinginterface
orreturntothemaininterface.Shortpresstoswitch
settingoptions.Aftersetting,longpressandto
returntothemaininterface.
Parameter setting and definition
P02: Mileage unit
Afterenteringthesettinginterface,thenpressto
switchtoP02:pressortoselect0(MILE-default)
or1(KM).
P04: Sleep time
From0to60minutes,0meansalwayson.After
enteringthesettinginterface,thenpresstoswitch
toP04:press ortoselectfrom0to60(Default:5
minutes).
P06: Wheel diameter
Calculatedbyinch,theprecisionis0,1.Afterenteringthe
settinginterface,thenpresstoswitchtoP06:press
ortoselectthediameter(Default:10).
P07: Number of tachometer magnets
Range:1-100.Afterenteringthesettinginterface,then
press   toswitchtoP07:pressortoselectthe
numberofthemagnets(Default:30).
P09: Zero start
Afterenteringthesettinginterface,thenpressto
Function menu settings