Select a flat mounting surface so that combustion air can
enter from all sides. Drill one hole of φ83. Seal (Fig. 8-8),
with the plane facing the exhaust cowl. Wear the fixing
clip before installing the exhaust pipe (Figure 8-3). Pay
attention to the installation of the smoke cap upwards。
20mm at the end of the exhaust pipe should be
compressed, do not straighten. Insert the exhaust pipe
into the exhaust cowl interface（Figure 8-10），as deep
as possible. Try to fix the clips on the top, tighten.
Place the air intake pipe (Figure 8-2) over the exhaust
cowl tooth (Figure 8-11). Set on the fixed clip（Figure8-
7）, tighten. Secure the exhaust cowl with 6 screws
(Figure 8-9). Use 2 screws to fix the exhaust cowl.
Fix the exhaust pipe on the side wall with mounting clip
（Figure8-7）.
Connect Air Inlet and exhaust pipe to The Heater
20mm at the end of the exhaust pipe (Figure 9-1)should
be compressed, do not straighten.
Try to insert the exhaust pipe on exhaust port (Figure 9-
2)as deep as possible. fix the clip on top, tighten.
Place the air intake pipe (Figure 9-3) over the air inlet
port (Figure 9-5). Set on the fixed clip (Figure9-6）,
tighten.
Warm Air Intake
The warm air intake is drawn in by the heater. There
must be a total area between the room and the heater
not less than 150cm2 opening.
Ensure that the warm air intake is not contaminated by
the engine or heater exhaust, if necessary, with
structural isolation measures.
To Next Page
Loading...