JPRiDE JPT2 - Essential operations and functions; MFB


2.Essentialoperationsandfunctions



button function operation
MFB
Power on
(TX/RX)
In power off status, press MFB around 2 seconds, blue
LED flashes twice,
JPT2 is powered on. If JPT2 didn’t
connect with any device before, it will enter into pairing
mode automatically after power on, with Blue and Red
LED flashes alternately

Power off
(TX/RX)
In power on state, press MFB around 2 seconds, Red
LED flashes twice (if release MFB immediately when
Red LED lighten, Red LED may only flashes once),
JPT2 power off; Please re-power on the unit after power
off the unit 3 seconds later since the voltage of the
chipset may not disappear totally

Play/Pause
RX In music playing, short press MFB to play/pause
music

Paringbutton
(TX/RX)
In standby status or connected status, short press“Paring button”（last for
0.2 second）enter into pairing mode, Blue and Red LED flashes
alternately; In connected standby status, press“Paring button” 3 seconds
quit connected status, enter into paring mode again

Volumeup/nextsong
（RX）
long press “Volume up” button to switch next song, short press“Volume
up”button” to increase volume
volumedown/
previoussong
Long press “Volume down” button to switch previous song, Short press
“Volume down” button” to decrease volume

ModeSPDIF/AUX
Power on default setting SPDIF mode，when insert Φ3.5mm audio cable,
automatic switch to AUX mode；when pull out Φ3.5mm audio cable
switch to SPDIF mode
In SPDIF mode, TX status put the optical fiber into SPDIF TX port, RX
status put the optical fiber into SPDIF RX port

StatusTX/RX
Switch between RX receiver/TX transmitter status
Once switch the status, the pairing information for the former mode will be
cleared up
Please don’t switch TX/RX mode within 3 seconds after powered off
