JPRiDE JPT2 - TX transmitter usage; 3.1 In TX status bluetooth pair and connect


3.TXtransmitterusage
3.1InTXstatusbluetoothpairandconnect
A．Power off status pull TX/RX button to TX side，long press MFB 2 seconds to power
on，after blue LED flashes twice,
JPT2 power on, when paring list is clear (JPT2 didn’t
connected with any devices before), power on then enter into pairing mode automatically,
Blue and Red LED flashes alternately

B．
Power on the unit and standby status, short press “Paring button”（last for 0.2
second）enter into pairing mode, Blue and Red LED flashes alternately
C．Put your devices（bluetooth headset、speaker or receiver）power on and enter into
paring mode，usually LED flash style is blue and red LED flashes alternately or blue
LED flashes quickly
D．Put
JPT2with your device together and wait for 5-30 seconds，after connect
successfully，blue LED flashes once then disappear
E．When you want to use in AUX mode, just insert the Φ3.5mm audio cable then SPDIF
mode automatically switch to AUX mode；when you want to use in SPDIF mode, pull the
Φ3.5mm audio cable out then automatically switch to SPDIF mode










