JR XP662 - Trainer System

14
XP662 MANUAL Introduction
The XP662 features a built-in trainer system. The
transmitter can be used as either a master (trainer) or
as a slave (trainee). The XP662 is compatible with all
other current JR radios that have built-in trainer
systems. An optional Trainer Cord (JRPA130)
is needed .
1. Match the servo reversing and trims of both radios.
2. Plug the optional trainer cord into both transmitters.
3. Turn on the master transmitter.
(Note: The slave radio must be left off.)
4. Test all the control functions on your aircraft with
the master radio.
5. Push the trainer button on the master
transmitter and check all the control functions
with the slave radio.
CHAPTER 5: TRAINER SYSTEM
•
Introduction
TRAINER SYSTEM5
D.S.C.
TRAINER
CORD INPUT
ON
TRAINERELEVATOR D/R
0
1
0
1
AILERON D/
R
SCROLL
CHANNEL
INCREASE
DECREASE
622
FUNCTION 3-4 1-4 FUNCTION 1-2 2-3
MULTI
DATA
DISPLAY
VOLTAGE
INDICATO
R
ON
TRAINERELEVATOR D/R
FLIGHT MODE
GEAR/MIX
0
1
THROTTLE HOLD
FLAP/MIX
0
1
AILERON D/
R
SCROLL
CHANNEL
INCREASE
DECREASE
622
XP662
FUNCTION 3-4 1-4 FUNCTION 1-2 2-3
MULTI
DATA
DISPLAY
VOLTAGE
INDICATO
R
TRAINER
BUTT
ON
OPTIONAL
TRAINER CORD
(JRPA
130)
MASTER TX
POWER SWITCH ON
SLAVE TX
POWER SWITCH OFF
THROTTLE CUT
DIGITAL TRIM EQUIPPED 6 CHANNEL
MULTI-DATA DISPLAY SYSTEM
ENTER
ENTER
XP662
DIGITAL TRIM EQUIPPED 6 CHANNEL
MULTI-DATA DISPLAY SYSTEM
THROTTLE CUT
FLIGHT MODE
GEAR/MIX
THROTTLE HOLD
FLAP/MIX
Operating the Trainer System