JR XP662 - Quick Start (Helicopter); Travel Adjustment

6
XP662 MANUAL Introduction
AIRPLANE
Travel Adjustment
CHANNEL
SCROLL
INCREASE
DECREASE
ENTER
TRV ADJ.
AIL
+I00
%
9
Press the SCROLL
button until
“TRV ADJ” appears
on the screen.
Press the CHANNEL
button to select the
channel on which you
want the travel adjusted.
CHANNEL
SCROLL
INCREASE
DECREASE
ENTER
TRV ADJ.
AIL
+I00
%
10
INCREASE
To increase the travel,
move the stick (i.e. aileron)
to the right then press the
INCREASE button to
adjust the right travel.
Release the INCREASE
button and move the same
stick to the left. Press the
INCREASE button to
adjust the left travel.
DECREASE
To decrease the travel,
move the stick (i.e. aileron)
to the right then press the
DECREASE button to
adjust the right travel.
Release the DECREASE
button and move the same
stick to the left. Press the
DECREASE button to
adjust the
left travel.
CHANNEL
SCROLL
INCREASE
DECREASE
ENTER
TRV ADJ.
AIL
+I00
%
11
Press the SCROLL and INCREASE buttons
upwards simultaneously to return to the main
screen and exit the Function mode.
Throttle Auto Cut
Before the initial start of your model, please check to
ensure that when the THROTTLE CUT button is pressed,
the engine’s carburetor barrel will move to the fully closed
(engine off) position.
This safety feature ensures that the engine can be shut off
immediately in case of a problem or safety concern.
Please note that the throttle cut button is only active when
the throttle stick is below 1/2 throttle, and a trim value has
been added to the throttle trim lever.
12
QUICK START
THROTTLE CUT BUTTON